Loading ...
Loading ...
Loading ...
After using stair/upholstery nozzle
Follow the irlstructions for "After cleaning" on page 9.
Drain suction hose by turning deep cleaner on and holding
nozzle up for several minutes, Do not press trigger.
Disconnect deep cleaner from electrical outlet.
Disconnect ho..e and ,.olution tube from deep clea_ner.
Drain sdution tube by placing round end in sink, and raising
nozzle above your head, Press the trigger,
I CONVERTER
_ CONVERTER
CLIP
O_casionally, debris may become lodged inside of the [lose at
the converter end.
To clean-out the [lose, lift bottom of converter clip with a screw
driver and remove clip. Remove debris as shown.
SOLUTION
HOSE
Snap clip back into positon makirlg sure solution [lose is not
pinched and moves freely.
Replace recovery tank front panel Slide panel down until it
snaps firmly in place.
Read "Before you begin cleaning" instructions on page 9.
Attach hose ,_lnd S_-qLltJ_-_n tube ,_l,_ instructect on p._ges 1 1 and I 2.
Agitator brushes will not rotate while "solution tube" is
connected to deep cleaner.
Fill cle_lrl ,_-qution tank ;w_cording to instructions on pages 7 and
8. Use 5 _,un. es of HOOVER Carpet/Upholstery Detergent.
Hose length may require that machine be placed at the top of
the stairs to clean upper half of stairway and at bottom of
stairs to clean lower half,
To prevent machine from falling, use extra caution when
cleaning on stairs. Do not place deep cleaner on stairs.
Do not point stair/upholstery nozzle at people or pets.
Dry h;,nds _nd pk_g deep dean÷r into a properly grounded
outlet.
Turn deep cleaner on,
2
Pre-spray the carpeted stair by holding tile nozzle about one
inch above the carpet and push the wand forward while
pressing tile solution trigger (equals one wet stroke).
Position nozzle against the riser and slightly press nozzle into
carpet pile, Press the solution trigger and pull the nozzle
slowly over the carpet (second wet stroke).
Release the trigger, lift nozzle, and po_,ition it against riser,
Pull nozzle Slowly over carpet witllout pressing trigger (dry
stroke),
It is best to alterna_te wet and dry stroke5 a_s de_.cribed a_bove.
End witln more dry strokes to aid in f_ster ciryincj of c_rpet,
Overlap strokes by one-half inch to help prevent stre._kirlg.
To avoid saturating carpet, do not use more than 4 wet
strokes over any one area. Always end with dry strokes.
NOTE: Check the recovery tank for fullness often. Empty
tank if it appears full even ifa_utornati_ shut-oft (pg. 6) has not
engaged.
If additional cleaning is necessary, wait until the carpet _s
completely dry before using the nozzle again,
When finished cleaning, follow "After cleaning" irlstructions on
page 9 and "After using stair/upholstery nozzle" instructiorls on
page 13.
_f_irlllnhnl_t_r_/ n_771_ . _l_nlnn c-_rn_fc=_l _f_ir_ 4
Loading ...
Loading ...
Loading ...