Sony MPC3610/1 VENICE 6K Digital Motion Picture Camera

User Manual - Page 22

For MPC3610/1.

PDF File Manual, 116 pages, Read Online | Download pdf file

MPC3610/1 photo
Loading ...
Loading ...
Loading ...
2. Preparation
00022
Attaching a Viewfinder
Available viewfinders for the unit
DVF-EL200: OLED color viewfinder
DVF-L700: LCD color viewfinder
Viewfinders are available separately.
This section describes attachment of the DVF-
EL200 as an example.
For details about attaching each viewfinder, refer to the
operating instructions of the viewfinder.
[CAUTION]
Do not leave the unit with the eyepiece of the
viewfinder facing the sun. Direct sunlight can
enter through the eyepiece, be focused in the
viewfinder, and cause fire.
[Notes]
Attach/remove the viewfinder while the unit is turned off.
A VF cable (A-2201-632 or A-2201-633-A) is required in
order to attach the DVF-L700. Also, turn the unit on after
setting the POWER switch of the DVF-L700 to the ON
position.
Attaching a Viewfinder
1 Align the viewfinder shoe with the groove of
the viewfinder mount on the VF attachment,
and attach the viewfinder.
2 Turn the viewfinder lock lever in the LOCK
direction to secure it in position.
2
1
Lock lever
3 Connect the viewfinder and unit using the VF
connection cable.
Viewfinder side:
Position the connector with the mark (red) at
the top, and fully insert the connector.
Camera side:
Alight the concave part of the VF connector
with the connector mark (red), and fully insert
the connector.
Clamper
[Note]
Secure the cable in the clamper as required.
To remove the viewfinder
1 Disconnect the VF connection cable from the
viewfinder and unit.
2 Turn the lock lever in the direction opposite to
LOCK, then remove the viewfinder from the VF
attachment.
Adjusting the Viewfinder Position
To adjust the front/rear position
1 Loosen one or both of the front/rear rod lock
levers of the VF attachment.
2 Slide the VF attachment forward/rearward to
adjust the viewfinder position.
11
11
2
2
Rod lock
levers
3 Tighten the rod lock levers.
[Note]
If a rod lock lever is difficult to turn, pull the lever out,
turn it to a position where it is easier to operate, and
then push the lever back in.
Loading ...
Loading ...
Loading ...