Loading ...
Loading ...
Loading ...
30
5. CLI Commands
show name
Use the show name command to display the name entered for the AutoProbe entry.
Syntax
show name
Examples
The following command displays the entry’s name:
console> probe (probe ABC)> show name
probe ABC
autoprobe: primary
primary address
Use the primary address command to set the IP address of the primary network device that the AutoProbe entry will probe.
Both IPv4 and IPv6 addresses are supported.
Syntax
primary address <address>
• address – Specifies the primary IPv4 or IPv6 address of the entry.
Examples
The following command specifies “172.17.77.88” as the primary address of entry “SnmpProbe”:
console> probe (SnmpProbe)> primary address 172.17.77.88
Update complete
primary oid
Use the primary oid command to set the SNMP OID that the AutoProbe entry will probe. This command applies only to SNMP
probes.
Syntax
primary oid <oid>
• oid – Specifies the OID that the entry will use for probe tests.
Examples
The following command specifies “1.3.6.1.2.1.1.3.0” as the OID to use for entry “SnmpProbe”:
console> probe (SnmpProbe)> primary oid 1.3.6.1.2.1.1.3.0
Update complete
Loading ...
Loading ...
Loading ...