Loading ...
Loading ...
Loading ...
(C_o_Ve_ti_g tO L_ _S (or Converting Back to Natural Gas from LP)
This range leaves the factory set for use with natural gas.
If you convert to LP gas, keep these instructions and ori-
fices in case you want to convert back to natural gas.
Prepare the Range for Conve_'sion
CAUTiON--Before converting the range:
(1) Turn off gas supply at the wall and
(2) Turn off the electrical power to the range.
If range has not yet been connected to gas supply, or
if flexible connection was made, range may be pulled
out from the wall to make conversion easier.
TooDsRequired:
• T-IO Torxdriver (for sealed burners)
o 1/2" and 3/4" open-end wrench
o Flat blade screwdriver (small)
o Nut drivers or wrenches: 7ram, 5/16" or a small
adjustable (depending on the size of the spuds)
$2÷@ t
Convert The Pressure Reguaator
i ARNING: Do not remove the pressure regu- ]
lator from the range.
1
1. For models equipped with sealed burners, remove
the storage drawer, broiler drawer or kick panel and
locate the pressure regulator at rear of the range.
Access Cover
On some models, you may have to remove an access
cover also.
For models equipped with dual burners, remove the
cooktop and locate the pressure regulator at right rear
of range.
2. Follow the directions in A or B, that match your reg-
ulator type.
DuamBurner Models
(models with lift-up cooktops)
If it is regulator A:
1. Use a coin to remove the cap from the pressure
regulator.
2. Turn the cap over and hook it into the slots.
The type of gas to be used should now be visible
on the top of the cap.
37
Sealed Burner Models
(models without lift-up cooktops)
if it is regulator B:
1. Unscrew the plastic-protected hex-nut cap from the
regulator.
2. Carefully pry the protective plastic cap off
the threaded metal cap. Gently pull the plastic
washer off the threads on the other side of the
metal cap.
3, Push the plastic cap onto the end of the metal cap
displaying the type of gas you are converting to.
Press the attached plastic washer onto the threads
on the other side of the metal cap.
4. Screw the hex-nut cap back into the regulator. Do
not overtighten.
SEALED BURNERS
Levershownclosed.
PUSH DOWN
TO OPEN.
Gas
Flow
Do not remove Cap Assembly
this protective cap
except for conversion
(continued next page)
Loading ...
Loading ...
Loading ...