Loading ...
Loading ...
Loading ...
4
Seal the Openings
Seal any openings in the wall behind the range and
in the floor under the range when hookups are
completed.
Light the Pilots
(for models equipped with standing pilots)
The range should be installed in its permanent posi-
tion before any pilots are lit or adjusted.
Light the Surface Burner Pilots
CAUTION: Make sure the surface burner control
knobs are in the OFF position before attempting to
light the pilots.
1. Raise the cooktop.
2. Light both pilots with a match.
3. To avoid pilot outage, use caution when closing
cooktop after lighting pilots.
NOTE: Do not leave standing pilot lit in a newly con-
structed or remodeled home or apartment that will be
unoccupied for more than a month.
Each pilot flame was adjusted at the factory to be
approximately 5/16" (8 mm) tall. A tinge of yellow
appearing at the upper tip is normal. If you find pilot
adjustment is necessary, follow instructions at right,
Adjust the Surface Burner Pilots if Necessary
1. Raise the _I _1
cook-
top.
2, Locate ___/'1_ ""x
the pilot It ___-J L _\
adjust- It I!' _---_/' H_\
ment • _ _,_ -']
screw. It c__ __ ]
through th__ /
the center of the manifold N,. J
panel.
3. To adjust, use a blade-type screwdriver with a shaft
diameter of less than 3/16" (5 mm). Turn pilot
adjustment screw until pilot is 5/16" (8 ram) high.
Do not reduce the flame to less than 5/16" (8 ram)
or pilot outage may occur. A pilot flame burning
higher than recommended may generate soot (car-
bon black) on the bottom of your cooktop.
Light the Oven Pilot
CAUTION: Make sure the OVEN CONTROL knob is
in the OFF position before attempting to light the pilot.
1,
Remove the broiler drawer by sliding the drawer all
the way out and then lifting slightly to remove it
from its tracks.
Locate the pilot at the _ _.
back of the broiler com- _'n ,_ I -_N
partment. The pilot is f I11_1 I\
attached to the left side of _' IIq!
the oven burner. _ _EJF'_
Light the pilot with a \_l_,
match. No adjustments _,. I _ /
are required for natural _ I. _"
gas. For LP gas, see _._'_=_
How to Convert the , ,_,
Range for Use with LP
Gas or Natural Gas. __1_--I_
, _, Itl _
33
Loading ...
Loading ...
Loading ...