Loading ...
Loading ...
Loading ...
Using Your Oven
:,: i : ,::: : ,:i _,
Before Using Your Oven
Be sure you understand how to set the control proper-
ly. Practice removing and replacing the shelves while
the oven is cool. Read the information and tips on the
following pages. Keep this manual handy where you
can refer to it, especially during the first weeks of
using your new range.
Lighting instructions for
Standing Pilot ModeUs
Some models have standing oven pilots that must be
lit initially.
To light the oven pilot:
1. Be sure the OVEN CONTROL knob is in the OFF
position.
2. Open the broiler drawer and remove the broiler pan
and rack. This will make it easier for you to reach
inside the broiler compartment.
3. Find the oven pilot port at the back of the broiler
compartment. The long tube, running from front to
back, is the oven burner. The pilot port is at the
back, about one inch below the burner.
4, Using a long match or match holder, reach in and
light the oven pilot.
,,To light the oven burner, turn the OVEN CON-
TROL knob to the desired temperature. The burner
should light within 60 seconds.
o Proper flame configuration, while using the oven
burner, visually check the burner flame in the broiler
compartment. If flame does not burn as described in
the Installation section of this manual, adjust the
flame following the directions on those pages.
o Power failure: An electrical power failure will not
affect a lighted standing oven pilot.
Lighting Hnstructions for
Electric ignition Models
The oven burner is lighted by electric
some models). _ ::
To light the burner, turn the OVEN CONTROL !
to the desired temperature. The burner should ignite:_i:i:ii:ii,:iiiii
within 30-90 seconds. : .... i
After the oven reaches the seiected temperaiu:_ei:
oven burner cycles--off completelyl therl on with a full: i::i:i
flame--to keep the oven temperature €ont!olledi :i
Power Outage
CAUTION: Do not make any attempt tO operate the
electric ignition oven during an electrical powerfail_
ure. The oven or broiler cannot be lit during a p(
failure. Gas will not flow unless the glow bar is
If the oven is in use when a power failure ocCurSi
the oven burner shuts Off and cannot be re-lit Until
power is restored.
Oven ControU
The OVEN CONTROL knob is
located on the control panel on /.
the front of the range. Simply
turn the knob to the desired
cooking temperatures.
tt will normally take 30-90 sec-
onds before the flame comes k_
on. After the oven reaches the
selected temperature, the oven
burner cycles--off completely,
then on with a full flame--to
maintain the selected tempera-
ture.
•i•••!•:•:/•• • _:••i_•••/•
•
Oven Light (onsomemodels)
Use the switch on the control panel to turn the oven
light on and off.
!0
Loading ...
Loading ...
Loading ...