Loading ...
Loading ...
Loading ...
2. Preparation
18
Attaching Devices
Clamp Lever Operation
Operate the clamp levers when attaching/
removing or adjusting the position of the
microphone and viewfinder.
When attaching, turn the clamp lever
clockwise to secure the rod.
When removing or adjusting the position, turn
the clamp lever counterclockwise to loosen
the clamp lever.
If a clamp lever is in a position that makes it
difficult to turn, pull the clamp lever off and
rotate it to an angle that will make operation
easier. Then place the clamp lever back on.
Clamp lever
Adjusting the Microphone Holder
Position
Loosen the clamp lever, and turn the
microphone holder to move it forward/
backward to adjust the position.
Clamp lever
Microphone holder and microphone
orientation
Attach so that the microphone holder and
microphone are oriented as shown in the
following diagram.
Replacing the Microphone Rod
[Notes]
The microphone rod is attached when shipped from
the factory.
Attach/remove the microphone rod while the
camcorder is turned off.
Attach/remove the microphone rod with the body
cap attached so as not to damage the image sensor.
1 Loosen the screw.
2 Withdraw the microphone rod.
3 Attach the microphone rod in the reverse
sequence.
Attaching the Viewfinder
[Note]
Attach/remove the viewfinder while the camcorder
is turned off. If the viewfinder is removed while the
camcorder is turned on, the camcorder will restart
automatically.
1 Loosen the viewfinder clamp lever, and
insert the viewfinder onto the microphone
rod.
Clamp lever
2 Adjust the left/right positioning of the
viewfinder, tighten the clamp lever,
connect the viewfinder cable to the
viewfinder connector of the camcorder,
and secure the viewfinder cable in the
cable clamper.
Cable clamper
[Note]
Check that the viewfinder is securely attached. The
viewfinder may fall off during shooting if the clamp
lever is loose.
Loading ...
Loading ...
Loading ...