Loading ...
Loading ...
Loading ...
110
7. External Device Connection
Connecting External Monitors and Recording Devices
To display recorded/playback pictures on an
external monitor, select the camcorder output
signal and use an appropriate cable for the
monitor to be connected.
You can also connect recording devices, such
as a VTR, and record the output signal from
the camcorder.
You can display the same information that
is visible in the viewfinder, such as status
information and menus, on an external
monitor. Set Output Display (page 92) in the
Monitoring menu to On for the corresponding
type of signal to output to the monitor.
SDI OUT Connector (BNC type)
Set the output on/off setting and the output
format in the Monitoring menu (page 92).
Use a commercially available 75 Ω coaxial
cable for connection.
[Note]
Check that the connection between the camcorder
and the external device is grounded before turning the
devices on.
(It is recommended that the camcorder and
external device be turned on after connecting
the 75 Ω coaxial cable.)
If the external device must be connected
to the camcorder while the camcorder is
on, connect the 75 Ω coaxial cable to the
external device first and then connect it to the
camcorder.
To start recording on the camcorder and
external device simultaneously
With SDI signal output enabled, set SDI/
HDMI Rec Control (page 82) >Setting in
the Project menu to SDI/HDMI Remote I/F or
Parallel Rec to enable output of a REC trigger
signal to the external device connected to
the SDI OUT connector. This will synchronize
recording on the external device with the
camcorder.
[Notes]
If a connected external device does not support a REC
trigger signal, the device cannot be operated.
When the record START/STOP button and the handle
record START/STOP are set to control different media,
the REC trigger signal is output in accordance with the
operation of slot A.
Only the REC trigger signal is output when there is no
media currently inserted.
HDMI OUT Connector (Type A
connector)
Set the output on/off setting and the output
format in the Monitoring menu (page 92).
Use a commercially available high-speed
HDMI cable for connection.
Loading ...
Loading ...
Loading ...