Loading ...
Loading ...
26
PROBLEM 6: SOLDERING IRON TEMPERATURE DISPLAY PANEL
SHOWS “PLUG” CHARACTERS
Case 1: The system shows “PLUG” from the soldering iron temperature
display panel .
SOLUTION 1: Check if the soldering iron connection assembly is properly
connected and secured to the receptacle on the control panel.
SOLUTION 2: Make sure the soldering iron tip is properly inserted and
secured inside the handle. Loose contacts between the tip and handle can also
cause this error message.
PROBLEM 7: AIR PRESSURE LEVEL IS SIGNIFICANTLY LOW NO
MATTER HOW HIGH THE AIRFLOW LEVEL IS CALIBRATED
Case 1: Check the mains voltage (AC power source). If the voltage level falls
significantly low, about 15-20% lower than the standard, there will also be a
noticeable drop in the air pressure level.
SOLUTION:
Please refer to your local power service provider.
Case 2: The microcontroller might have detected the operating frequency
incorrectly. The user will notice that airflow level is weaker with reference to the
airflow gauge compared with the displayed value.
SOLUTION:
Turn off the unit and on again to let the device re-detect the proper operating
frequency
TROUBLESHOOTING GUIDELINES
3
The BK8000 dual port Lead-Free Repairing System is a reworking
equipment that has a Hot Air Gun, Soldering Iron, Smoke Absorber, and
Desoldering Gun in one system.
The dual port system allows simultaneous use of the desoldering
gun and soldering iron.
The nozzle is has air spreader technology to disperse heat and air
evenly greatly enhancing the heat output for more effective reflows.
When paired with our fourth generation BGA nozzle technology,
reworking larger BGAs (CPUs GPUs) will be even more efficient and
repeatable.
The Hot air gun is equipped with our BlackJack SolderWerks Hot
-air triple protection system, which provides (1) System cool-
down, (2) Auto System Sleep, and (3) Overheat Protect. The
System cool-down feature removes the residual heat from nozzle
when the Hot-air function is switched off, this will let the nozzle cool
down more rapidly and pro-long the life of the heating element. The
Auto System Sleep feature puts hot-air gun in sleep mode when
the hot-air gun has been left unattended. The Overheat Protect
feature effectively shuts off power to the heater when an overheat
in the handle has been detected.
It has several advanced features such as solder iron and
desoldering gun digital calibration, configurable auto sleep for the hot-
air gun, soldering iron and desoldering gun.
There is an automated function that allow the programming of a 5
segment reworking profile for automated and consistent reflows.
Finally, the unique, innovative design with digital control panel and
display provides precision, safety, and ease of use to match all
reworking requirements.
PRODUCT DESCRIPTION
Loading ...
Loading ...
Loading ...