Loading ...
Loading ...
Loading ...
6
A. Main Station
As soon as the equipment has been removed from the package,
REMOVE THE SCREW located at the center of the bottom of the
main unit. This screw holds the pump in place during transportation.
B. Soldering Iron
1. See instructions on 2663B soldering iron holder assembly guide
on page 10.
2. Connect the soldering iron cord assembly to the soldering iron
output terminal found at the lower middle portion of the main
unit.
3. Place the soldering iron to the soldering iron stand.
C. Smoke Absorber
1. Attach the smoke absorbing tube to the suction vacuum cap.
Make sure the cord connections are free from tangles.
D. Hot Air Gun
The Hot Air Gun holder was installed on the station upside down for
packaging purpose. To set up the Hot Air Gun holder:
1. Loosen the two screws that secure the holder to the station.
2. Turn the holder right side up.
3. Re-fasten the two screws.
4. Place the hot air gun onto the holder in preparation for usage.
E. Desoldering Gun
1. Connect the cord of the desoldering gun to the desoldering gun
terminal .
2. Connect the vacuum tube to the suction vacuum cap.
3. Place the desoldering gun onto the holder in preparation for
usage.
WARNING: Failure to remove the screw before using the
equipment can cause damage to the system.
Initial Setup
23
4. Inside the pipe, the quartz glass and heat insulation are installed.
Loosen the cable and take out the heating element.
5. Insert new heating element and reconnect the terminal.
Be careful
not to rub Heating Element wire.
6. Reconnect the ground wire after replacing the element.
7. Assemble the handle again.
Soldering Iron Error Messages
1. Soldering Iron connection assembly is not connected or not
properly connected to the receptacle on the control panel.
2. Soldering iron tip is damaged and needs to be replaced. The
device will display “PLUG”.
3. Indicating a problem with the contacts of the soldering iron
or the tip.
De-Soldering Gun
1. Before usage dampen the filter pads with a little bit of water to allow
efficient air passage and filter action, re-dampen pads frequently for
maximum efficiency.
2. Routinely clean Spring Filter, and replace filter pads when they are dirty or
clogged .
3. The solder pathway can be cleaned using the provided Nozzle cleaning pin,
use the cleaning pin when pathway seems clogged.
De-Soldering Gun Disassembled illustration:
Filter barrel
S p r i n g
Filter Barrel
Filter Pads
F i l t e r
De-soldering Gun
Heating
N o z -
Securing
Heater ex-
ternal hous-
OPERATING GUIDELINES
Loading ...
Loading ...
Loading ...