Circuit Specialists BK8000-PLUS INSTRUCTION MANUAL

Loading ...

SOLDERING IRON Holder assembly

Case 3: The Suction Vacuum cap is connected to the Smoke Absorber

Terminal or Vacuum cap instead of the Wire mesh cap.

SOLUTION:

Change the cap to the Wire mesh cap. This allows more air to pass through the

system. Make sure as well that the vacuum tube of the soldering iron or

desoldering gun is not connected.

Case 4: The Wire mesh cap is connected but airflow level is still low.

SOLUTION:

Check the filter pad inside for dirt that can block the air passage. Clean or

replace if necessary.

ADDITIONAL SOLUTION: Check for any tangles in the tube of the hot air

gun that can cause the air blockage.

PROBLEM 8: UNIT SHOWS UNCONVENTIONAL BEHAVIOR

Description: Unit operates erratically.

SOLUTION1: Try to switch OFF the device and switch ON again. Unplug the

system from the main power source and plug in again when necessary

SOLUTION2: Restore unit to default factory setting. switch off/on the unit

while holding the hot-air temperature down button until the banner finishes

scrolling, the unit would revert to its default factory setting.

Circuit Specialists BK8000-PLUS 3-in-1 Hot Air Rework Soldering