Loading ...
Loading ...
Loading ...
13
English
(2) Avoid recharging at high temperatures.
A rechargeable battery will be hot immediately after
use. If such a battery is recharged immediately after
use, its internal chemical substance will deteriorate,
and the battery life will be shortened. Leave the
battery and recharge it after it has cooled for a while.
CAUTION
●
When the battery charger has been continuosly
used, the battery charger will be heated, thus
constituting the cause of the failures. Once the
charging has been completed, give 15 minutes
rest until the next charging.
●
If the battery is charged while it is heated
because it has been left for a long time in a
location subject to direct sunlight or because
the battery has just been used, the pilot lamp of
the charger lights for 1 second, does not light for
0.5 seconds (off for 0.5 seconds). The battery will
not be recharged. In such a case, let the battery
cool before charging.
●
When the pilot lamp fl ickers (at 0.2-second
intervals), check for and take out any foreign
objects in the charger’s battery connector. If
there are no foreign objects, it is probable that
the battery or charger is malfunctioning. Take it
to your authorized Service Center.
PRIOR TO OPERATION
1. Preparing and checking the work environment
Make sure that the work site meets all the conditions
laid forth in the precautions.
2. Checking the battery
Make sure that the battery is installed fi rmly. If it is at
all loose it could come off and cause an accident.
3. Power switch
Ensure that the power switch is in the OFF position.
If the battery is installed while the power switch is in
the ON position, the power tool will start operating
immediately, which could cause a serious accident.
4. Checking the Accessory
○
Check to see if the application tool is a genuine
component recommended by the manufacturer and
that there are no cracks or other damage.
○
Check to see if the application tool is properly installed
as instructed.
5. Changing application tools (Fig. 7)
CAUTION
●
Be sure to switch power OFF and disconnect the
battery from the body when changing application
tools.
●
Never touch the application tool immediately
after use. The metal is hot and can easily burn
your skin.
●
The lever is attached to a strong spring. Be very
careful not to get your fi ngers caught when
pushing the lever down.
NOTE
○
Make sure the facing of the application tool is correct.
○
Make sure the application tool is properly set on the
protrusion of the attachment ring.
(1) Pull the lever up. There will be some resistance, but
make sure the lever is pulled until it is parallel with the
main unit.
(2) Pull and turn the guide sleeve until “
” is aligned with
the “
” mark.
(3) Pull out the tool shaft.
(4) Attach the application tool to the attachment ring,
making sure the tool’s hole is fi tted to the ring’s
protrusion. The angle of attachment for the application
tool can be set in 30° increments.
(5) Insert the tool shaft.
(6) Align the guide sleeve’s “
” mark to the “ ” position.
(7) Push down the lever.
(8) Align the holes when sticking the sanding paper to the
sanding pad.
000BookCV18DBLUSmetabo.indb13000BookCV18DBLUSmetabo.indb132021/03/3014:46:482021/03/3014:46:48
Loading ...
Loading ...
Loading ...