Loading ...
Loading ...
Loading ...
21
[PBP]: Picture by Picture
Open up a sub-window
side-by-side of another
signal source.
A (main) B
When the sub source is
not detected:
A (main) B
Note
The black strip located on the top
and the bottom of the screen is for
measuring the correct aspect ratio when
in the PBP mode. If you expect to see full-
screen, adjust your device's resolutions
to pop-up attention resolution and you
will able to see 2 devices' source screen
project to this display without black
strips. It is important to note that the
analog signal is not supported on full
screen in PIP mode.
• PIP / PBP Input: There are different
video inputs to choose from as the
sub-display source: [1 HDMI 2.0], [2
HDMI 2.0], [DisplayPort] and [USB
C].
Please refer to the table below for
compatibility of the main/sub-input
source.
SUB SOURCE POSSIBILITY (xl)
Inputs
HDMI 1 HDMI 2 DisplayPort USBC
MAIN
SOURCE
(xl)
HDMI 1
● ● ● ●
HDMI 2
● ● ● ●
DisplayPort
● ● ● ●
USBC
● ● ● ●
• PIP Size: When PIP is activated,
there are three sub-window sizes
to choose from [Small], [Middle],
[Large].
B
A (main)
Small
Middle
Large
• PIP Position: When PIP is activated,
there are four sub-window positions
to choose from.
Top-Left Top-Right
B
A (main)
B
A (main)
Bottom-Left Bottom-Right
B
A
(main)
A (main)
B
Swap: The main picture source and
the sub-picture source are
swapped on the display.
Swap A and B source in [PIP] mode:
B
A (main)
↔
B (main)
A
Swap A and B source in [PBP] mode:
A (main) B
↔
B (main) A
• O: Stop MultiView function.
A (main)
Note
When you activate the SWAP function,
the video and its audio source will swap
at the same time.
Loading ...
Loading ...
Loading ...