Loading ...
Loading ...
Loading ...
l lnstallation Instructions I Range
I If you have questions, coil 1.800.GE.CARES or visit our Website at: ge.com
I
I
In the Commonwealth of Massachusetts:
• This product must be installed by a licensed plumber
or gas fitteE
• When using ball-type gas shut-off valves, they shall
be the T-handle type.
• A flexible gas connector, when used, must not exceed
3 feet.
BEFOREYOU BEGIN
Readthese instructions completely and carefully.
Installation of this range must conform with local
codes, or in the absence of local codes, with the
National Fuel Gas Code, ANSI Z223.11NFPA.54, latest
edition. In Canada, installation must conform with
the current Natural Gas Installation Code, CANICGA-
B149.1 or the current Propane Installation Code,
CANICGA-B149.2, and with local codes where
applicable. This range has been design-certified bg
CSA International according to ANSI Z21.1, latest
edition and Canadian Gas Association according to
CANICGA-I.1 latest edition.
As with any appliance using gas and generating heat,
there are certain safety precautions you should follow
You will find these precautions in the Important Safety
Information section in the front of this manual Read
them carefully
• IMPORTANT- Savethese instructions for
local electrical inspector's use
• IMPORTANT- Observeall governing codes
and ordinances
• Note to Installer - Be sure to leave these
instructions with the Consumer.
• Note to Consumer - Keepthese instructions for
future reference
• Note -This appliance must be properly grounded
• Servicer - The electrical diagram is in an envelope
attached to the back of the range
• Skill level -Installation of this appliance requires basic
mechanical skills
• Proper installation is the responsibility of the installer
• Product failure due to improper installation is not covered
under the Warranty.
PART INCLUDED
Anti-Tip bracket kit
FOR YOUR SAFETY
Do not store or use combustible materials, gasoline or
other flammable vapors and liquids in the vicinitg of this
or ang other appliance.
If you smell gas:
O Open windows
Don't touch electrical switches
Extinguishany open flame
Immediately call your gas supplier.
TOOLS YOU WILL NEED
Phillipsscrewdriver
Flat-blade screwdriver
Pencil and ruler
Pipe wrenches (2)
(one for backup)
Open-end or
adjustable wrench
Level
Drill, awl or nail
MATERIALS YOU MAY NEED
• Gas line shut-off valve
• Pipejoint sealant or UL-approved pipe thread tape with
Teflon* that resists action of natural and LP gases
• Flexiblemetal appliance connector (1/2" I.D.)
A 5-foot length is recommended for ease of installation
but other lengths are acceptable Never use an old
connector when installing a new range
• Flare union adapter for connection to gas supply line
(3/4" or 1/2" NPTx 1/2" I.D.)
• Flare union adapter for connection to pressure regulator
on range (1/2" NPTx 1/2" I.D.)
• Liquid leak detector or soapy water.
• Lag bolt or 1/2" O D sleeve anchor (for concrete floors
only)
*Teflon: Registered trademark of DuPont
34
Loading ...
Loading ...
Loading ...