Loading ...
Loading ...
Loading ...
12
1. With pasta cooker tank full of water, pilot burner can be lit.
2. Check gas supply is turned ‘On’ at mains supply.
3. Depress and rotate gas control knob to ‘PILOT’ position and hold knob depressed.
4. Open front access door and depress piezo igniter located on bulkhead panel, until pilot burner
ignites.
5. Continue holding gas control knob depressed for approx. 10 to 15 seconds after igniting pilot burner,
then release, pilot burner should remain alight.
6. Ensure pilot burner is alight, by checking that pilot flame is alight with access door open.
7. If pilot burner does not ignite, repeat Items 1 to 6 above.
1. Depress and rotate gas control knob to ‘High Flame’ position, main burner will ignite automatically
off pilot burner.
2. Gas control knob can be regulated between 'High Flame' and 'Low Flame' position to regulate
cooking temperature.
3. It will take approximately 30 minutes to heat water in tank from 20°C to 100°C.
IMPORTANT:
THE USE OF ROCK SALT IS NOT PERMITTED IN THIS MACHINE .
NEVER add salt to cold water - always ensure that the water in the pasta cooker is
boiling before adding salt.
Clean the pan regularly after each use.
To the ‘Pilot’ Position
a. Depress and rotate gas control valve clockwise to ‘Pilot’ position.
b. Main burner will extinguish and ‘Pilot’ will remain alight.
To the ‘Off’ Position
a. Depress and rotate gas control valve fully clockwise to ‘Off’ position.
b. ‘Pilot’ burner will extinguish.
IMPORTANT:
Should any abnormal operation like;
- ignition problems,
- abnormal burner flame,
- burner control problems,
- partial or full loss of burner flame in normal operation, be noticed, appliance requires
IMMEDIATE service by a qualified service person and should not be used until such service
is carried out.
Loading ...
Loading ...
Loading ...