Loading ...
Loading ...
Loading ...
Installation
*INSTALLATION*
82
Flush-fit installation
Create the worktop cut-out.
Remember to maintain the minimum
safety distances (see “Safety
distances”).
Solid wood, tiled and glass worktops:
Fix a wooden frame 5.5mm or 7mm
(depending on the model) below the
top edge of the worktop.
Risk of damage from incorrect
connection.
The hob electronic module may be
damaged if a short-circuit occurs.
The mains connection cable must be
connected to the hob by a qualified
electrician.
Connect the electrical connection
cable by following the instructions in
the wiring diagram on the hob (see
“Wiring diagram” in the “Electrical
connection” chapter).
Stick the supplied sealing strip under
the edge of the hob. Do not apply the
sealing strip under tension.
The sealing strip is not required for the
following models:KM7404FX,
KM7414FX, KM7414FXGlas.
Feed the mains connection cable for
the hob down through the worktop
cut-out.
Centre the hob in the cut-out.
The gap between the ceramic glass
surface and the worktop must be at
least 2mm wide. This is required so
that the hob can be sealed.
Connect the hob to the power supply.
Check that the hob works.
Seal the gap between the hob and
worktop with a silicone sealant that is
heat-resistant to at least 160°C.
Damage from unsuitable sealant.
Unsuitable sealant can damage
natural stone.
For natural stone worktops and
natural stone tiles, only use silicone
sealant that is specially formulated
for natural stone. Follow the
manufacturer’s instructions.
Loading ...
Loading ...
Loading ...