Loading ...
Loading ...
Loading ...
Installation
*INSTALLATION*
76
Surface-mounted installation
Create the worktop cut-out.
Remember to maintain the minimum
safety distances (see “Installation –
Safety distances”).
Seal any cut surfaces on wooden
worktops with a special varnish,
silicone sealant or resin to prevent the
wood from swelling as a result of
moisture ingress. The sealant must
be heat-resistant.
Make sure that the sealant does not
come into contact with the top of the
worktop.
Stick the supplied sealing strip under
the edge of the hob. Do not apply the
sealing strip under tension.
Risk of damage from incorrect
connection.
The hob electronics may be
damaged if a short-circuit occurs.
The power cable must be connected
to the hob by a qualified electrician.
Connect the power cable by following
the instructions in the wiring diagram
on the hob (see “Installation –
Electrical connection”).
Feed the power cable for the hob
down through the worktop cut-out.
Place the hob centrally in the cut-out.
When doing this, make sure that the
seal of the appliance sits flush with
the worktop on all sides. This is
important to ensure an effective seal
all round.
If the seal does not sit flush with the
worktop in the corners, the corner
radius (≤R4) can be carefully cut to fit
using a jigsaw.
Connect the hob to the electricity
supply (see “Installation – Electrical
connection”).
Check that the hob works.
Loading ...
Loading ...
Loading ...