Loading ...
Loading ...
Loading ...
Installation
*INSTALLATION*
70
Flush-fit installation
A flush-fit hob is suitable only for
installation in natural stone (granite,
marble), solid wood and tiled
worktops. Certain models are also
suitable for building into glass
worktops – these are marked with an
appropriate note in “Installation –
Installation dimensions – flush-fit”.
When using a worktop made from any
other material, please check first with
the worktop manufacturer that it is
suitable for installing a flush-fit hob.
The internal width of the base unit
underneath the appliance must be at
least as wide as the inner worktop cut-
out (see “Installation – Installation
dimensions – flush fit”), so that the
hob is easily accessible from
underneath after installation and the
casing can be removed for
maintenance. If the underside of the
hob is not freely accessible after
installation, any sealant used must be
removed to enable the hob to be lifted
out of the cut-out should this be
necessary.
Natural stone worktops
The hob is set directly in the cut-out.
Solid wood worktops, tiled worktops,
glass worktops
The hob is secured inside the cut-out
with wooden battens. The battens must
be provided on site, and are not
supplied with the appliance.
Sealing strip
Dismantling the hob for service
purposes may damage the sealing
strip underneath the edge of the hob.
Always replace the sealing strip
before reinstalling the hob.
Loading ...
Loading ...
Loading ...