Loading ...
Loading ...
Loading ...
Operation
15
Lighting Pilot Burner
1. Remove centre casting with casting removal tool.
2. Push-in control knob and rotate anti-clockwise to PILOT position.
3. With control knob depressed, manually light pilot burner located in front of main burner.
4. Hold in control knob for approximately 10 to 15 seconds, then release.
5. The pilot burner should remain alight. If not repeat Items 2 to 4 above until pilot burner lights.
Lighting Main Burner
1. Ensure pilot burner is alight by checking through hole in centre of front control panel or by removing
centre casting with casting removal tool.
2. Rotate control knob anti-clockwise to position marked HIGH.
3. Main burner will ignite automatically off pilot burner.
4. Once lit, main burner will be burning at full rate. For a lower heat turn knob fully anti-clockwise to
LOW position.
5. For intermediate heat, position control knob between HIGH and LOW positions.
NOTE: Always set control knob to HIGH position when lighting main burner. If pilot burner goes
out during normal operation, wait 5 minutes before relighting.
6. Cast iron work surface has a heat pattern that can be used effectively by positioning cooking pans
etc. appropriately according to heat requirement.
350 / 400
300 / 350
250 / 300
200 / 250
Heat Pattern for Target Top on Full Heat (°C)
Heat Pattern for Target Top on Low Heat (°C)
200 / 250
150 / 200
250 / 300
Fig 4
Fig 5
Should any abnormal operation like;
- ignition problems,
- abnormal burner flame,
- burner control problems,
- partial or full loss of burner flame in normal operation, be noticed, appliance requires
IMMEDIATE service by a qualified service person and should not be used until a service is
carried out.
IMPORTANT
Loading ...
Loading ...
Loading ...