Loading ...
Loading ...
Loading ...
/nsta// TheProtectorSystem®(Continued)
iNSTALLiNGTHE BRACKETS
Be sure power to the opener is disconnected. Install and align
the brackets so the sensors will face each other across the
garagedoor, with the beam no higher than 6" (15 cm) above the
floor. They may be installedin one of three ways, as follows.
Garage doortrack installation (preferred):
1. Slip the curved arms over the rounded edge of each door
track, with the curved arms facing the door. Snap into place
against the side of the track. It should lie flush, with the lip
hugging the back edgeof the track, as shown in Figure 1.
if your door track will not support the bracket securely, wall
installation is recommended.
Waft installation (Figures2 & 3):
1. Placethe bracket against the wall with curved arms facing the
door. Besure there is enough clearancefor the sensor beam
to be unobstructed.
2. If additional depth is needed,an extension bracket (see
Accessories) or wood blocks can be used.
3. Use bracket mounting holes as a template to locate and drill
(2) 3/16" diameter pilot holes on the wall at each side of the
door, no higher than 6" (15 cm) above the floor.
4. Attach bracketsto wall with lag screws (not provided).
5. If using extension brackets or wood blocks, adjust right and
left assemblies to the same distance out from the mounting
surface. Make sure all door hardware obstructions are cleared.
Floor installation (Figure 4):
1. Usewood blocks or extension brackets (see Accessories) to
elevatesensor brackets so the lenseswill be no higher than
6" (15 cm) above the floor.
2. Carefully measure and place right and left assemblies at the
same distance out from the wall. Be sure all door hardware
obstructions are cleared.
3. Fastento the floor with concrete anchors as shown.
Figure 1
Figure2
Figure3
DOORTRACK MOUNT (RIGHT SIDE)
Track
Lip
WALL MOUNT (RIGHT SIDE)
Indicator
Light
FastenWood Block to Wall with
(Not provided)
Indicator
Light Safety
Reversing
Sensor
Bracket
Lag Screws
-. (Not provided)
Lens ...... _@
WALL MOUNT (RIGHT SIDE)
Extension Bracket
See Accessories)
(Provided with
Extension Bracket)
Carriage Bolt
1/4"-20xl/2"
HARDWARESHOWN ACTUAL SIZE
Wing Nut
1/4"-20
InsulatedStaples
(NotShown)
(Provided with
Extension Bracket) _'"
k_
Lens
Figure4
FLOORMOUNT (RIGHT SIDE)
24
Safety
Reversing
Sensor
Bracket
Indicator
Light
-- ttach with
Concrete Anchors
; (Not provided)
Light
Safety
Reversing
Sensor
Bracket
Loading ...
Loading ...
Loading ...