Loading ...
Loading ...
Loading ...
iNSTALLATiON STEP 1 2
Install TheProtectorSystem®
iMPORTANTiNFORMATiONABOUTTHESAFETYREVERSING
SENSOR
The safety reversingsensormust be connectedand aligned
correctlybeforethegaragedooropenerwill moveinthedown
direction.
The sending sensor (with an amber LED)transmits an invisible
light beam to the receiving sensor (with a green LED). If an
obstruction breaksthe light beam while the door is closing, the
door will stop and reverseto the full open position, and the
garagedoor opener lights will flash 10 times.
NOTE:For energy efficiency the garage door opener will enter
sleep mode when the door is fully closed. Thesleep mode shuts
the garagedoor opener down until activated. Thesleep mode is
sequenced with the garage door opener light bulb, as the light bulb
turns off the sensor LEDs will turn off and whenever the garage
door opener lights turn on the sensor LEDs will light. Thegarage
door opener will not go into the sleep mode until the garagedoor
opener has completed 5 cycles upon power up.
When installing the safety reversing sensors check the following:
• Sensors are installed inside the garage,one on either side of
the door.
• Sensors are facing each other with the lensesaligned and the
receivingsensor lens does not receive direct sunlight.
• Sensors are no more than 6 inches (15 cm) above the floor and
the light beam is unobstructed.
Besure power is NOTconnected to the garage door opener
BEFOREinstalling the safety reversing sensor.
To prevent SERIOUSINJURY or DEATHfrom a closing garage
door:
• Correctly connect and align the safety reversing sensor. This
required safety device MUST NOT be disabled.
• install the safety reversing sensor so beam is NO HIGHER
than 6" (15 cm) above garage floor.
Safety Reversing Sensor
6" (15 cm) max. above floor
Invisible Light Beam
Protection Area
Safety Reversing Sensor
6" (15 cm) max. above floor
Facing the door from inside the garage
23
Loading ...
Loading ...
Loading ...