Loading ...
Loading ...
Loading ...
The light becomes constant.
Press the button – Fig. 11.
The light flashes during the pre-heating.
Once the preheating is finished, the light stays constant and you can start the steam production by pressing
the button again. Press the button again to stop the cycle.
The appliance goes back to its initial position if the steam control is not used after 2 mins.
BE CAREFUL, BECAUSE THE CYCLE DOES NOT STOP IMMEDIATELY.
Frothing milk
We recommend that you use pasteurized or UHT milk that has been recently opened. Untreated milk does not
give the best results.
Pour the milk into your milk jug. Immerse the nozzle in the milk Fig. 12. Initiate the steam function as explained
in the paragraph above. Once your milk is frothy enough – Fig. 13 – again press the button to stop the cycle. To
remove any milk traces from the steam nozzle, place a container under the nozzle and restart a preparation with
steam (around 10 seconds).
The steam nozzle can be removed for more intense cleaning. Wash it out with water and a little washing-up liquid
and a small non-abrasive brush. Rinse and dry it Fig. 14. Before putting it back, ensure that the air inlet holes
are not blocked by any milk residues. If necessary, unblock them using the needle supplied – Fig. 15.
Do not wash the steam nozzle in a dishwasher. To interrupt the steam function, simply press any button. If
the nozzle is obstructed, unblock it with the needle provided. Steam can be produced for a maximum of 2 minutes
per cycle.
After the steam function has been used, the nozzle can be hot, and we recommend that you wait for a few
moments before handling it.
Auto-cappuccino XS 6000 Set (sold separately)
This auto-cappuccino accessory enables you to make cappuccinos or lattes – Fig. 16. Connect the different parts
to each other. Ensure that you do not pierce the pipe by keeping the button in the correct place. After removing the
lid, fill the jug with milk – Fig. 17 and place a cup or glass under the auto-cappuccino nozzle – Fig. 18. Select the
cappuccino or latte position on the special nozzle – Fig. 19. Start the steam, as indicated in the chapter ‘Making
drinks with steam’. Once you have made the milk froth, place your cup under the coffee outlets and start a coffee
cycle – Fig. 20.
To prevent the milk from drying on the auto-cappuccino accessory, ensure that you clean it thoroughly. You are
advised to wash it immediately by running a steam cycle with the accessory jug filled with water in order to clean
the inside of the nozzle. You can use the KRUPS liquid cleaner for this, available separately.
MAINTAINING YOUR APPLIANCE
Emptying the coffee grounds collector and the drip tray.
If the light flashes,
Remove, empty, and clean the coffee ground collector – Fig. 21.
Replace the coffee grounds collector – Fig. 22
Remove, empty, and clean the drip tray – Fig. 23.
The drip tray is equipped with floats to indicate when it needs to be emptied.
Put all parts back in place.
As soon as you remove the coffee grounds collector, you will have to empty it completely to avoid any overflow.
Loading ...
Loading ...
Loading ...