Loading ...
Loading ...
Loading ...
If you unplug the appliance during cleaning, press the button, or there is an electrical power cut, the cleaning
program will start again from the beginning. In this case, another cleaning tablet may be necessary. Make sure to
carry out the full cleaning cycle to ensure good maintenance of your appliance.
The cleaning cycle is intermittent: do not put your hands under the water outlets ‘E’ and ‘W’ while the cycle is in
progress.
Only use KRUPS (XS3000) cleaning tablets. We cannot be held responsible for any damage that may result from
the use of tablets from other brands. You can obtain cleaning tablets from KRUPS Service Centres.
Scale removal program – total duration: about 20 minutes
The quantity of scale deposited depends on the hardness of the water used. The appliance will automatically warn
you by the ‘CALC’ light coming on when you need to proceed with scale removal. This program is only accessible
when the appliance requests it.
To benefit from the guarantee conditions, it is essential to perform the appliance’s scale removal cycle when
informed to do so. Be sure to follow the procedure closely step by step. You can continue to use the appliance
when the light is on, but you are advised to perform the program as soon as possible.
If your appliances fit with our Claris – Aqua Filter System F088 cartridge, please remove the cartridge during the
descaling operation.
Only use KRUPS scale removal products. You can obtain scale removal products from KRUPS Service Centres.
We cannot be held responsible for any damage that may result from the use of tablets from other brands.
Make certain to protect your work surface during cleaning and scale removal cycles, especially if it
is made of marble, stone or wood.
Start the descaling program by pressing the button. The ‘CALC’ light becomes constant and the indicator lights
and flash.
Remove and clean the drip tray.
Place a container with a minimum capacity of 0.6 l under the coffee outlets as well as under the steam nozzle –
Fig. 24. Empty the tank and refill it with warm water up to the line ‘CALC’ – Fig. 33. Dissolve a sachet of Krups (40
g) F054 descaler in the tank – Fig. 33. Replace the water tank. The indicator light switches off. Press the
button after carrying out all of these operations.
The first phase (approximately 8 min) begins.
The descaling cycle will start automatically.
At the end of this phase, the sound signal beeps every 10 seconds, and the indicator light flashes. Empty the
used water container and put it back in place. Empty and rinse the water tank – Fig. 34. Refill the tank with water
and put it back into place. The warning light goes out. Press the button again to start the second phase. The
sound signal stops. The second phase (about 6 min) begins. The program continues. It rinses the appliance and
removes any traces of the descaler. At the end of this phase, the sound signal beeps every 10 seconds Remove
and empty your used water container and put it back in place. Press the button again to start the final phase.
The sound signal stops. The inal hase (approximately 6 min) begins. The program continues. It removes the last
particles of descaler. When the descaling cycle is finished, the indicator light ‘CALC’ goes out. Refill your water
tank. Your appliance is ready for the next use.
If there is not enough water in the water tank, you will be warned by the light. Add the appropriate amount of water
to the tank and scale removal will continue automatically.
If you unplug the appliance during cleaning, press the button, or there is an electrical power cut, the
cleaning program will start again from the beginning. In this case, another cleaning tablet may be necessary.
Make sure to carry out the full cleaning cycle to ensure good maintenance of your appliance. The cleaning cycle is
intermittent: do not put your hands under the water outlets ‘E’ and ‘W’ while the cycle is in progress.
Long rinsing program – total duration: about 2 minutes
Loading ...
Loading ...
Loading ...