Loading ...
Loading ...
Loading ...
ENGLISH
7
• To switch the appliance on, press the ON/OFF
button
1
, then turn the SmartSelect™ dial
3
to the
desiredsetting.
• To switch the appliance off,
turn the SmartSelect™ dial to
off, then
press the ON/OFFbutton.
NOTICE: Never leave the steam mop in one spot
on any surface for any period of time. Do not store
with a wet pad as this can damage your floor. Always
place the steam mop with the handle tube
6
in the
upright position when stationary and make sure the
steam mop is turned off and unplugged when not
inuse.
NOTICE: Always empty the water tank afteruse.
SmartSelect
TM
Dial (Fig. A)
The steam mop is equipped with a SmartSelect™ steam
dial
3
which shows various hard surface cleaning
applications. To change the application, turn the
SmartSelect™ steam dial until the correct operating mode
for your particular hard floor surface isselected.
NOTICE: The dial has an "off" position. There will be
no steam flow when the dial is turned to this position
NOTICE: For garments and carpet, set the dial to to
the Wood/Laminatesetting.
NOTICE: Do not use on any unsealed hard floor
surfaces. Additionally, on surfaces that have been
treated with wax or some no wax floors, the sheen
may be removed by the heat and steam action. It
is always recommended to test an isolated area of
the surface to be cleaned before proceeding. We
also recommend that you check the use and care
instructions from the floor manufacturer.
Using the SmartSelect™ steam dial, choose from one of
the following applications. The steam mop will select
the correct volume of steam required for your particular
cleaningoperation.
Steam Mop Cleaning (Fig. A)
1. Place a cleaning pad
21
on the floor with the ‘hook &
loop’ side facingup.
2. Lightly press it down onto the cleaningpad.
3. Plug the steam mop electric cord into theoutlet.
4. Press the ON/OFF button
1
. It takes approximately 15
seconds for the steam mop to heatup.
5. Turn the SmartSelect™ steam d
ial
3
to the desired
setting to activate the steam pump. After a few seconds
steam will start to come out of the steam floor head at
the rate corresponding to the SmartSelect™ dialsetting.
NOTICE: If the system has been run dry it may take up
to 30 seconds to prime the system on firstuse.
NOTICE: It takes a few seconds for steam to enter the
cleaning pad. The steam mop will now glide easily
over the surface to be cleaned.
6. Push and pull the steam mop slowly across the floor to
thoroughly steam clean eachsection.
7. When you have finished using the steam mop, turn
the SmartSelect™ steam
dial to
off, unplug the steam
mop, and wait until the steam mop cools down
(approximately five minutes).
Steam Glove (Fig. L–O)
WARNING: Always use the steam glove as shown in
Figure L, with your hand inside the protectiveglove.
WARNING: Never attempt to use the steam glove by
gripping it externally as shown in Figure M. This will
result inscalding.
WARNING: Avoid using the steam glove in tight
corners as shown in FigureN.
WARNING: Should a problem occur during use, use
the quick release tab
15
to quickly remove the steam
glove from your hand as shown in FigureO.
Figure L
Figure M
Figure N
Figure O
Loading ...
Loading ...
Loading ...