Loading ...
Loading ...
Loading ...
7
Figure 1-8
1.1.3.2 Isolating Camera
For our own camera brand, the case and the negative end of the power has been isolated.
There is no need to isolate the camera. If you are using the camera from the third party, please
check it needs to be isolated or not.
Step 1 Check whether it needs to isolate the camera or not.
Use multimeter to check there is current between camera case and the power
negative end or not. If there is current, please isolate the camera.
Step 2 How to isolate the camera.
Install on the insulating decorative pane. The decorative pane is on the vehicle.
Install camera on the insulation pane and then secure the insulation pane on the
vehicle.
1.2 Install Device Antenna
It is to connect device to the network so that to pin point vehicle position.
1.2.1 Mobile Network Antenna
Caution
If you want to paste the antenna, make sure the bottom material cannot be metal.
For the antenna of large chuck, please make sure it is straight up and is sucking on the
metal. In some special circumstance, if the sucking material is not the metal, you can use
two-sided 3M paste or using the glue to secure.
Refer to Figure 1-9 to install the mobile antenna in the vehicle. For the big flat antenna or the
antenna of large chuck, please make it is straight up near the window shield (on the instrument
pane, at the bottom of the window shield). Or you can install inside of the instrument pane.
Refer to Figure 1-10 to install the mobile antenna outside of the vehicle. The antenna of large
chuck is at the top of the vehicle or the trunk.
Loading ...
Loading ...
Loading ...