Loading ...
Loading ...
Loading ...
User's Manual
91
Table 4-37 Description of light parameters
Parameter Description
F1/2/3
Select the light type connected to each port.
The light type must be the same as the actual connected
light type. Otherwise, the light might be damaged.
Flashing Light
Working Mode
●
No Flash
: The light is normally off.
●
Always Flash
: The light is normally on.
●
Auto Flash
: Configure the preset value of brightness.
If the ambient brightness is lower, the light
automatically turns on; if higher, the light
automatically turns off.
Scene Mode
Select the scene mode for the flashing light from
Morning/Dusk
,
Day
and
Night
, indicating different
brightness of the light which suits the environment the
best.
Pulse Width
Configure the pulse width of flashing light. The higher
the value, the brighter the light.
Delay Time
Configure the delay time of the light to keep the
snapshot in sync with the flash.
Trigger Mode
You can select the level that triggers the flashing light.
Currently, only
Low level
is supported.
Strobe
Output Mode Same as
Working Mode
of flashing light.
Frequency Set the frequency of the strobe.
Ambient
Brightness
When setting
Output Mode
to
Auto
, you need to set the
ambient brightness.
Step 3 Click
Save
.
4.5.6 Storage
You can configure the storage path of snapshots and recorded videos.
4.5.6.1 Storage Spot Config
Step 1 Select
Setting
>
Storage
>
Storage
>
Storage Spot Config
.
Figure 4-61 Storage spot config
Step 2 Select storage path as needed.
●
Local Storage
: Store in the TF card, which has a limited capacity but offers continuous
Loading ...
Loading ...
Loading ...