Loading ...
Loading ...
Loading ...
© Copyright, Alliance Laundry Systems LLC - DO NOT COPY or TRANSMIT
Operating Instructions
70458301ENR6
78
Electronic OPL Micro Control
OM Control Suffix
1. To use an Automatic Cycle, press an ON/
SELECT pad. Select HIGH, MEDIUM,
MED LOW, LOW or NO HEAT for items that
should not be dried with heat. A light to the left
of the selected pad lights up.
HIGH temperature* 185°F (85°C)
HIGH temperature** 190°F (88°C)
MED temperature* 160°F (71°C)
MED temperature** 165°F (74°C)
MED LOW temperature
*
145°F (63°C)
MED LOW temperature
**
155°F (68°C)
LOW temperature (025-055) 120°F (49°C)
* = (025, 030)
** = (035, 055)
To use a Time Dry or Custom Cycle, refer to the
Programming Manual.
Figure 35
NOTE: Do not press directly on lights or the center
of pad. For proper selection, press on pad slightly
to the right of center. Refer to Figure 36.
Figure 36
2. Press START pad to start tumble dryer.
Figure 37
NOTE: All pads can be pressed in any sequence
without damaging control or tumble dryer. To stop
the tumble dryer at any time, open the door or
press STOP/RESET.
Figure 38
NOTE: The window display will flash. Press STOP/
RESET twice (within three seconds) to end the
cycle and reset the control to idle status. To restart
the tumble dryer, CLOSE door and press START
pad.
IMPORTANT: If the loading door or lint panel
door is opened during the cycle, the heating system
will shut off and the motor will stop. To restart the
cycle, both doors must be closed and START pad
must be pressed.
3. When the cycle is complete, open door and
remove the laundry.
NOTE: This machine includes an anti-wrinkle/
extended tumble feature. After the drying cycle is
complete, the cylinder will tumble without heat
every few minutes. The intermittent tumbling will
continue for one hour or until the door is opened.
TMB1483N
TMB806N
HIGH
MEDIUM
MED LOW
LOW
NO HEAT
ON / SELECT
TMB1485N
TMB1484N
START
STOP/RESET
WARNING
To prevent the risk of fire, remove laundry
immediately in case of power failure.
W779
Loading ...
Loading ...
Loading ...