Loading ...
Loading ...
Loading ...
© Copyright, Alliance Laundry Systems LLC - DO NOT COPY or TRANSMIT
Installation
35
70458301ENR6
8. Load the cylinder with a full load of clean rags
and run to remove oil or dirt from cylinder.
9. Check the airflow switch operation refer to
Adjustments section. The heating systems should
shut off when the lint panel is opened a
maximum of 1.5 inches (38 mm).
The airflow switch operation may be affected by
shipping tape still in place, clogged lint screen,
failure to remove wire tie, lack of make-up air, or
an obstruction in the exhaust duct. These should
be checked and the required corrective action
taken before attempting to adjust the airflow
switch. To adjust the airflow switch, refer to
Adjustments section.
10. Wipe out the cylinder using an all-purpose
cleaner or detergent and water solution. Refer to
Figure 13.
IMPORTANT: The use of chlorine bleach for
removing any discoloration should be avoided
because bleach could damage the finish.
Figure 13
If the tumble dryer does not meet ANY of the listed
requirements, remove tumble dryer from use. Refer to
Removing Tumble Dryer from Service section.
Required for CE Models Only
Once machine is installed, please be sure to complete
the following items:
Review and verify machine operation with
customer.
Leave all literature and a signed Declaration of
Conformity with customer.
Review machine warranty information with
customer.
Apply warning sticker on front panel of machine,
in language appropriate to country of sale
(included in literature packet).
T452I
Do not operate tumble dryer if airflow
switch is faulty. An explosive gas mixture
could collect in tumble dryer if airflow
switch does not operate properly.
W407R1
WARNING
T452I
Loading ...
Loading ...
Loading ...