Loading ...
Loading ...
Loading ...
© Copyright, Alliance Laundry Systems LLC - DO NOT COPY or TRANSMIT
Installation
27
70458301ENR6
Position and Level the Tumble Dryer
Remove lint panel door, and unscrew the four shipping
bolts (one at each corner). Remove tumble dryer from
skid.
NOTE: Do not throw bolts away – they are the
leveling legs.
Remove four nuts from the literature package, and
screw one fully on to each leveling leg.
Screw the four leveling legs (bolts) back into the level
adjusting fittings from the bottom.
Slide tumble dryer to its permanent location. Adjust
the leveling legs until the unit is level, or no more than
0.125 inch (3.18 mm) higher in the front. Refer to
Figure 3. Tumble Dryer must not rock. Lock leveling
legs with nuts previously installed.
NOTE: The front of the tumble dryer should be
slightly higher than the rear (approximately
0.125 inch [3.18 mm]). This will prevent the clothes,
while tumbling, from wearing on the door glass
gasket.
IMPORTANT: Keep tumble dryer as close to floor
as possible. The unit must rest firmly on floor so
weight of tumble dryer is evenly distributed.
Figure 3
The stacked tumble dryer has a fifth leveling leg which
is shipped in the up position. The fifth leveling leg
MUST BE installed properly on the lower left side of
the blower housing to stabilize the tumble dryer. Refer
to Figure 4.
After leveling with the four cabinet leveling legs,
lower the fifth leveling leg so it contacts the floor, and
then secure the screws.
Figure 4
T483I
T483I
T467I
1 Fifth Leg
The stacked tumble dryer has a 5th leveling
leg on the blower housing. It is very
important to properly adjust this leg. Unit is
back heavy and could rock or tip.
W250R1
CAUTION
1
Loading ...
Loading ...
Loading ...