Loading ...
Loading ...
Loading ...
© Copyright, Alliance Laundry Systems LLC - DO NOT COPY or TRANSMIT
Installation
29
70458301ENR6
Figure 6
Connect inlet hoses to water supply. Flush the lines for
approximately two minutes to remove any foreign
materials that could clog the screens in the water
mixing valve. This is especially important when
installing a tumble dryer in a newly constructed or
renovated building. Then connect the hoses to the
Y-valve; connect the Y-valve to the connections at the
rear of the tumble dryer.
IMPORTANT: Thread hose couplings onto valve
connections finger tight, then turn 1/4 turn with
pliers. Do not cross thread or overtighten
couplings.
IMPORTANT: Hoses and other natural rubber
parts deteriorate after extended use. Hoses may
develop cracks, blisters or material wear from the
temperature and constant high pressure they are
subjected to.
All hoses should be checked on a yearly basis for
any visible signs of deterioration. Any hose showing
the signs of deterioration listed above should be
replaced immediately. All hoses should be replaced
every five years.
NOTE: Longer inlet hoses are available (as
optional equipment at extra cost) if the hoses
supplied with the tumble dryer are not long enough
for installation. Order hoses as follows:
Part No. 20617 Inlet hose 8 feet (2.44 m)
Part No. 20618 Inlet hose 10 feet (3.05 m)
NOTE: Replacement outlet hoses are available
(at extra cost). Order 44073304 Hose, 14 in.
(36 cm).
Electrical Requirements
No independent external power source or supply
connection is necessary. Power to operate the 24 Volt
fire suppression system is from the rear junction/
contactor box.
TMB2008N
1 Lock
2 Hose Couplings
3 Y Valve
4 Inlet Hoses
5 Opening for Auxiliary Alarm Cable
1
2
3
2
4
5
Electrical power must be provided to
tumbler at all times. The fire suppression
system will be inoperative if the main
electrical power supply is disconnected.
W690
WARNING
Loading ...
Loading ...
Loading ...