Loading ...
Loading ...
Loading ...
9
42 Power cord Electri cal parts 1
43 Clipper of the power cord PP, fire-retar dant 1
44 Wiring Electri cal parts 1
OPERATING PROCEDURES & MAINTENANCE
UNPACKING YOUR ICE MAKER
1. Remove the exterior and interior packaging . Check if all the accessories, including instruction
manual, ice scoop, white water inlet pipe, 4 ways to 2 ways water quick connector and the water
draining pipe, etc., are inside or not. If any parts are missing, plea se contact our customer service.
2. Remove the tapes for fixing the door and inner cabinet, ice scoop, etc.. Roughly clean the inner
cabinet & ice scoop with wet clothe .
3. Put the ice maker on
a level & flat floor, without direct sunlight and other sources of he at (i.e.: stove,
furnace, radiator). Maker sure that there is at least 20cm gap between the air outlet and the
obstacles, and at least 5 cm between Left/Right side and the wall.
4. Allow 4 hours for the refrigerant fluid to settle before plugging the ice maker in if the unit maybe fall
upside down during shipping or transportat ion.
5. The appliance m ust be positioned so that the plug is accessible.
WARNING: connect to th e potable water supplying only. Only use drinking water.
INSTALLATION LOCATION REQUIREMENT
a) This unit is not for outdoor use. Keep the proper room temperature and inlet wat er
temperature according to above specification table. Otherwise it will affect the ice making performance.
b) This unit should not be located near any heat resource.
c) The unit should be located on a firm & level foundation at normal counter top height.
d) There must be at least 5CM clearance a
t rear side for connection and 25 CM clearanc e in
front to open the door and keep good air circulation.
e) Do not put anything on the top of the ice maker.
Side view (mm)
(mm)
40
40
Installation clearance
top view (1:10) (mm)
Loading ...
Loading ...
Loading ...