Loading ...
Loading ...
Loading ...
26 GETTING TO KNOW YOUR VEHICLE
HIGH/LOW BEAM SWITCH
With the low beams activated, pull the
multifunction lever toward the steering wheel to
turn on the high beams. The High Beam Indicator
Light will illuminate in the instrument cluster to
indicated that the high beams are on. Pull the
multifunction lever a second time to switch the
headlights back to low beam. When the ignition is
placed in the OFF position, both the high and low
beams will turn off.
FLASH-TO-PASS
You can signal another vehicle with your headlights
by lightly pulling the multifunction lever toward you.
This will cause the high beam headlights to turn on,
and remain on, until the lever is released.
PARKING LIGHTS
These lights can be turned on, with the ignition key
in the STOP (OFF/LOCK) position or removed, by
moving the end of the multifunction lever to O (off)
position and then to the headlight position.
The indicator light in the instrument panel comes
on. The lights stay on until the next ignition cycle is
performed.
FOLLOW ME HOME/HEADLIGHT DELAY
When this feature is selected, the driver can
choose to have the headlights remain on for a
preset period of time after the engine is turned off.
Activation
Remove the key or turn the ignition to the STOP
(OFF/LOCK) position, and pull the multifunction
lever toward the steering wheel within two
minutes. Each time the lever is pulled, the
activation of the lights will be extended by 30
seconds. The activation of the lights can be
extended to a maximum of 210 seconds.
The indicator light on the instrument panel will light
up and the corresponding message will appear in
the instrument cluster display for as long as the
function is activated. The indicator light comes on
when the lever is operated and stays on until the
function is automatically deactivated. Each
movement of the lever only increases the amount
of time the lights stay on.
Deactivation
Pull the multifunction lever toward the steering
wheel and hold it for more than two seconds.
FOG LIGHTS — IF EQUIPPED
The fog light switch is located on the center stack
of the instrument panel, just below the climate
controls.
Push the switch once to turn the fog
lights on. Push the switch a second time
to turn the fog lights off.
NOTE:
If the vehicle’s ignition is turned off, the fog lights
will also turn off.
TURN SIGNALS
Move the multifunction lever up or down and the
arrows on each side of the instrument cluster will
flash to show proper operation of the turn signals.
NOTE:
If either light remains on and does not flash, or
there is a very fast flash rate, check for a defective
outside light bulb.
LANE CHANGE ASSIST
Lightly push the multifunction lever up or down,
without moving beyond the detent, and the turn
signal will flash five times then automatically turn off.
BATTERY SAVER
To protect the life of your vehicle’s battery, when
the ignition is OFF and any door is left ajar for
15 minutes, the interior lights will automatically
turn off.
NOTE:
Battery saver mode is cancelled if the ignition is
placed in the MAR (ACC/ON/RUN) position.
21_VF_OM_EN_USC_t.book Page 26
Loading ...
Loading ...
Loading ...