Loading ...
Loading ...
Loading ...
208 SERVICING AND MAINTENANCE
FRONT TURN SIGNAL/PARKING LAMPS
See below steps to replace:
1. Remove one retaining screw on the lower
headlamp filler panel. Remove filler panel.
2. Remove two retaining screws on the upper
headlamp filler panel. Remove filler panel.
3. Remove one upper retaining screw from the
headlamp housing.
4. Remove two lower retaining screws from the
headlamp housing.
5. Pull Headlamp forward, disconnect the
harness electrical connector and remove the
headlamp assembly from vehicle.
6. Rotate the bulb counterclockwise and remove.
7. Install the bulb into socket, and rotate bulb/
socket clockwise into lamp locking it in place.
8. Carefully reinstall headlamp in the same
position on the vehicle, so as not to affect
headlamp aiming.
9. Install the one upper retaining screw on
headlamp housing.
10. Install the two lower retaining screws on
headlamp housing.
11. Carefully reinstall the lower headlamp filler
panel and one retaining screw.
12. Carefully reinstall the upper headlamp filler
panel and two retaining screws.
DAYTIME RUNNING LAMP (DRL)/FRONT SIDE
MARKER LAMP
See below steps to replace:
1. Remove one retaining screw on the lower
headlamp filler panel. Remove filler panel.
2. Remove two retaining screws on the upper
headlamp filler panel. Remove filler panel.
3. Remove one upper retaining screw from the
headlamp housing.
4. Remove two lower retaining screws from the
headlamp housing.
5. Pull Headlamp forward, disconnect the
harness electrical connector and remove the
headlamp assembly from vehicle.
6. Remove the (DRL), side marker bulb by pulling
straight out.
7. Replace lamp as required and lock in place.
8. Reinstall plastic cap.
9. Carefully reinstall headlamp in the same
position on the vehicle, as not to affect
headlamp aiming.
10. Install the one upper retaining screw on the
headlamp housing.
11. Install the two lower retaining screws on the
headlamp housing.
12. Carefully reinstall the lower headlamp filler
panel and one retaining screw.
13. Carefully reinstall the upper headlamp filler
panel and two retaining screws.
FRONT FOG LAMPS
See below steps to replace:
1. Turn front wheels inboard to access cover in
wheel liner.
2. Open the cover on the front of the wheel liner.
3. Remove connection and replace the bulb.
4. Connect the wire and rotate bulb/socket
clockwise into lamp locking it in place.
5. Reinstall the plastic cap and close the cover on
the wheel liner.
FRONT, REAR ROOF LAMPS
See below steps to replace:
1. Remove two screw and remove the lamp
assembly.
2. Remove the socket bulb by turning counter-
clockwise.
3. Remove bulb and replace as needed.
4. Reinstall the bulb socket and rotate clockwise
to lock in place.
5. Reinstall lamp.
21_VF_OM_EN_USC_t.book Page 208
Loading ...
Loading ...
Loading ...