Loading ...
Loading ...
Loading ...
1. Turn the “Hand Wheel” on cylinder clockwise until it stops to ensure the Cylinder Valve is fully closed.
2. Turn all of the burner knobs to the OFF position.
3. Connect the 3/8” Flare end of the hose to the 3/8” Flare end of the brass coupling on the unit using a
3/4” open wrench. Do not apply pipe sealant. (These are flared fittings).
Note: Remember the rubber line on the hose and regulator must be protected from sharp edges, hot
surfaces, aggressive building materials that could cut, melt, or damage the line. A separate approved gas
line might be needed to go between the hose and regulator and the oven to position the rubber line in a
safe location.
4. Connect the regulator to the LP cylinder. Only hand-tighten the regulator.
5. Check for leaks using a soapy water solution by spraying on all connections, including all of the valves,
fittings, lines etc. (any and all gas connections have the ability leak and therefore it is critical to check for
leaks before each use)
6. To disconnect after you have used the appliance, turn the burner knobs to the OFF position.
7. Close the Cylinder Valve by turning the Hand Wheel counter-clockwise until it stops.
8. Disconnect the regulator from the LP cylinder after use.
Blaze Outdoor Products Instructional
Book Page | 19
Loading ...
Loading ...
Loading ...