Loading ...
Loading ...
Loading ...
Do not use the appliance until the leak is corrected.
The adjacent diagram
is intended to show what a leaking
connect
ion would look like. These two locations are not the
only points to check nor the only potential areas for a gas
leak to
be present.
Blaze Outdoor Products Instructional
Book Page | 16
EX: Leak testing solution of soapy water by mixing in a spray
bottle one-part liquid soap to one part water.
All gas pipin
g and connections must be tested for leaks after installation or service along with before each
use. This includes all valves, pipe connections, joints, lines and every point from the gas source to the
burners.
The following diagram is for informational purposes only. These locations are not the only points to check
nor the only potential areas for a gas leak to be present. Ensure the leak test includes all valves, pipe
connections, joints, lines and every point from the gas source to the burners.
All leaks must be corrected immediately. Remember-before exchanging an empty bottle for a new
one; make sure all control valves are in the “off” position. This can create a low flow of gas through
the oven. This would require the tank to be disconnected from the regulator, and then reconnected
to reset the regulator.
Open the valve (shut-off or ‘ON’ LP tank). Test for leaks by applying liquid soap solution to all
joints. Bubbles forming indicate gas leak.
NEVER USE AN OPEN FLAME TO CHECK FOR LEAKS
Loading ...
Loading ...
Loading ...