Loading ...
Loading ...
Loading ...
PROBLEM POSSIBLE CAUSE PROBABLE CORRECTION
The machine doesn't
operate
The ice maker is unplugged. Plug the ice maker in.
The fuse is blown. Replace fuse. If it happens again,
call for service to check for a short
circuit in the ice maker.
The ice maker power switch
is OFF.
Turn the ice maker power switch ON.
The ice storage bin is full of ice. Remove some ice. Make sure water
curtain and micro-switch are closed.
The water doesn't feed in
after the ice maker starts.
The water supply tap is turn off. Turn on the water supply line.
The water supply pipe is not
proper connected.
Reconnect the water supply pipe.
Machine makes ice, but bin
does not ll up with ice
The condenser may be dirty. Clean the condenser air lter.
The air ow to the ice maker
may be obstructed.
Check the installation.
The ambient and water
temperatures are high, or the
machine is near some heat
source.
Check the installation.
Water is leaking from the unit.
A few water drops fall to the
oor when you open the
door to take out ice from
ice storage bin.
Normal condensation on the door or
some water together with ice. Take
care when you take out ice.
Water supply connection leaks. Tighten tting. See “Connecting the
water line”.
Cubes are partially formed
or white at the bottom.
Not enough water in
the water trough.
Check if the water supply
pressure is below 15 psig.
Check water supply--lter may be
restricted.
Check for a water leak at the
water trough.
Noise during operation
The feet are not leveled
and locked.
Level and lock the feet.
See “Leveling the Ice Maker”.
Certain sounds are normal. See Normal Sounds.
The ice maker stops suddenly
while making ice.
The electricity is off. Reconnected the power
supply line.
The room temperature is out
the stated range.
Cut off the electricity, let the ice
maker stop working until the
temperature returns within the
stated range.
The ice storage bin is full of ice.
Remove some ice cubes; Make sure
the water curtain and micro-switch
are close.
The body of the ice maker is
electried.
The grounding line isn’t in the
socket.
Use a socket meeting the required
electrical standard.
Scaling occur frequently
inside the machine.
The hardness of the water
is too high.
Use a water-softening device in
-
stalled in front of the water inlet.
17
Troubleshooting Guide
Loading ...
Loading ...
Loading ...