Loading ...
Loading ...
Loading ...
20 Eaton Tripp Lite SmartOnline Series User Guide 614-40204—Rev 01
Table 8. Display Functions (Continued)
Main Menu Submenu
Display Information or Menu function
RESET FAULT ST
The RESET FAULT ST command is used to reset all
faults. But some faults may not be cleared.
CLEAR EVENT LOG
The CLEAR EVENT LOG command is used to clear all
the event log.
RESET KWH USED
The RESET KWH USED is used to reset the power
used.
FACTORY SETT
The FACTORY SETT command restores the UPS to
original factory settings.
LOCAL SETTINGS
LANGUAGE
Sets the language displayed on the UPS.
AUDIBLE ALARM Allows the audible alarm to be enabled or disabled.
IN/OUT SETTINGS
OUTPUT VOLTAGE
Sets the UPS output voltage.
OUTPUT FREQUENCY
Sets the UPS output frequency.
HIGH EFFIC. MODE
Enables / Disables High-Efficiency mode.
OVERLOAD PREALARM
Sets the overload pre-alarm percentage.
ON/OFF SETTINGS
COLD START
Enables / Disables the ability for the UPS to start on
battery.
AUTO RESTART
Enables / Disables the UPS to restart when mains
power is available after a on battery shutdown.
AUTO START
Enables / Disables the UPS to start when mains
power is available.
START ON BYPASS
Enables / Disables the UPS to start in Bypass Mode
when mains power is available.
SLEEP MODE
Enables / Disables the UPS to enter into Sleep
Mode 90 minutes after the UPS is commanded to
shut down.
SITE WIRING FLT
Enables / Disables the UPS site wiring fault alarm.
BATTERY SETTINGS
AUTO BAT TEST
Sets the automatic UPS battery test interval.
RESTART LEVEL
Sets the UPS battery restart level percentage.
BAT LOW LEVEL
Sets the battery low alarm level percentage.
BAT LOW TIME
Sets the battery low remaining time in minutes.
COM SETTINGS
REMOTE ON/OFF
Sets the input signal function for REMOTE ON/OFF.
REMOTE PWR OFF
Sets the input signal function for REMOTE PWR OFF.
INPUT DB9-4
Sets the input signal function for INPUT DB9-4.
OUTPUT RELAY
Sets the output signal function for OUTPUT RELAY.
OUTPUT DB9-1
Sets the output signal function for OUTPUT DB9-1.
OUTPUT DB9-7
Sets the output signal function for OUTPUT DB9-7.
Display Functions
Loading ...
Loading ...
Loading ...