Loading ...
Loading ...
Loading ...
12 Eaton Tripp Lite SmartOnline Series User Guide 614-40204—Rev 01
33..99 CCoonnnneeccttiinngg tthhee PPoowweerr CCaabblleess
AAcccceessss ttoo TTeerrmmiinnaall BBlloocckkss
1. Remove the terminal blocks cover (one screw)
2. Punch out the knockouts and insert the cables/conduits inside.
High leakage current. Earth connection essential before connecting supply.
NOTE The L6-30P input power cable is attached by Eaton.
This type of connection must be carried out by qualified electrical personnel.
Before carrying out any connection, check that the upstream protection device (Normal AC source) is open "O"
(Off). Always connect the ground wire first.
If you ordered additional equipment, refer to the specific user manual to check the terminal blocks connection
of the UPS with this accessory.
OUTPUT
NORMAL AC SOURCE
L1L1
N(L2) N(L2)
Insert the Normal AC cable through the cable
gland.
Connect the three cables to the Normal AC source
terminal blocks.
Insert the Output cable through the cable gland.
Connect the three cables to the Output terminal
blocks.
Put back and secure the terminal blocks cover
with the screw.
Tighten the strain relief.
1
2
3
4
5
6
33..1100 DDeetteeccttiinngg OOtthheerr AAcccceessssoorriieess
Tip If you ordered other UPS accessories, refer to their specific user manuals to check the connection to the
UPS.
Connecting the Power Cables
Loading ...
Loading ...
Loading ...