Loading ...
Loading ...
Loading ...
16
To add a third remote/repeater unit, repeat steps 8 through 10. To finish
your installation with a B126-2A0 1x2 receiver unit, proceed to step 11.
11
Using Cat5e/6 cable, connect the RJ45 port on the repeater unit
marked OUTPUT to the RJ45 port on the B126-2A0 receiver unit
marked INPUT.
12
Connect a monitor to the OUTPUT 1 port on the receiver unit using a
Tripp Lite P568-Series High-Speed HDMI Cable.
13
Repeat step 12 for the OUTPUT 2 port on the receiver unit.
14
Connect the external power supply to the receiver unit and plug the
receiver unit into a Tripp Lite Surge Suppressor, PDU or UPS. The
green RJ45 LED illuminates to indicate that it is receiving power from
the external power supply.
15
Repeat steps 5 through 14 for each additional RJ45 OUTPUT port on
the transmitter unit.
16
Turn on the power to the connected devices. The orange RJ45 LEDs
on all units will illuminate to indicate that a signal is being received
from the HDMI source. The video image should now be displayed on
the connected monitors.
17
If necessary, use the Equalization control on the repeater and receiver
units to adjust the video image.
Note: An improper Equalization setting can cause the monitor not to display an
image at all. Try each setting until an acceptable image is displayed.
Extender/Splitter with
Remote/Repeater Installation
Loading ...
Loading ...
Loading ...