Loading ...
Loading ...
Loading ...
Before performing operations, set the operation mode selector
on the remote control to @SOURCE.
• All Channel Search mode
1 Press @SEARCH MODE (or @SRCH
MODE) repeatedly to select "ALL CH
SEARCH".
2 Press @PRESET/TUNING/CH <1/C> (or
@PRESET/CH /_ / V) repeatedly to search
for a channel within all channels.
• Youcan search for a channel quickly by pressing and
holding @PRESET/TUNING/CH <3/ t::>(or
@PRESET/CH A / V).
• To display the XM Radio ID numher displa>ed in the l?ont
panel display, selectchannel "0".
• Category Search mode
1 Press @SEARCH MODE (or @SRCH
MODE) repeatedly to select "CAT SEARCH".
2 Press @CATEGORY (or @A-E/CAT. <1 / C>)
repeatedly to change the channel category.
3 Press @PRESET/TUNING/CH <1 / C> (or
@PRESET/CH A / V) repeatedly to search
for a channel within the selected channel
category.
"4¢--
Youcan search lor a channel quickly by pressing and
holding @PRESET/TUNING/CH <3 / _ on the front
panel(or @PRESET/CH A / V on theremotecontrol).
• Preset Search mode
Prior to selecting it preset channel in the Preset Search
mode, yon must preset XM Satellite Radio channels. For
details, see "Setting the XM Satellite Radio preset
channels" on page 56.
"4¢--
The initial factory setting of all preset channels (AI to E8) is
"[001] Preview".
1 Press @SEARCH MODE (or @SRCH
MODE) repeatedly to select "PRESET
SEARCH".
2 Press @CATEGORY (or @A-E/CAT. <1 / _)
repeatedly to change the preset channel
group (A to E).
1
Press @PRESET/TUNING/CH <1 / _> (or
@PRESET/CH A / V) repeatedly to change
the preset channel number (1 to 8).
4¢--
You can also select the preset channel number directly by
pressing the numeric buttons (1 to 8) (1_)).
Direct number access mode
Press @SRCH MODE on the remote control
repeatedly to select "ALL CH SEARCH" or
"CAT SEARCH".
Press the numeric buttons (@) to enter the
desired three-digit channel number.
For example, to enter the number 123, press the
numeric buttons ((_)) as shown below.
ENTERTAIN
CLASSICAL LIV_CLUB
%-.-%--%
The display changes as follows.
.::i::.::Hi::...........i
.." ',..'hi ".. .....i ":=
% :' ": i i ," ,L .=1,,
./ '.2M ',. i ">":!'
% :"':i i ," ,L ,::., ',J
• To enter a one<ligit or two-digitchannel number, press the
numeric buttons (@) on the remote control and then press
@ENT to confirm the input number.
• Instead of pressing @ENT to tune into the channel
immediately, you can wait a few seconds until this unit
confirms the entered channel number.
• If nobutton is pressed within a few seconds alter you enter
a one-digit or two-digit number, this unit automatically
confirms the entered channel number.
• Pressing a button other than the numeric buttons ((g))or
@ENT cancels the Direct Number Access mode
procedure.
55 En
Loading ...
Loading ...
Loading ...