Loading ...
Loading ...
Loading ...
CAREANDCLEANING
RemovableParts (cont.)
Broil Stop Position
Hinge
TO REMOVE
1. Open the door to the broil stop
position.
2. Grasp the door at each side and
lift up and off the hinges. DO NOT
LIFT BOOR BY THE HANDLE.
_ AUTION: When the
door is removed and
the hinge arms are at
the broil stop position,
as a precaution, cover the hinge
arms with toweling or an empty
paper towel roll. Do not bump or
try to move the hinge arms while
working In the oven area. They
could snap back, causing injury
to the hands or damage the
porcelain finish of the front
frame.
TO REPLACE
1. Make sure the hinge arms areinthe
broil stop position.
2. Lift the door by the sides.
3. Line up the slots at the bottom edge
of the door with the hinge arms.
4. Slide the door down onto the hinge
arms as far as it will go.
5. Close the door.
TO CLEAN OUTSIDE OF DOOR
Use soap and water to thoroughly
clean the top, sides and front of the
oven door. Rinse well. You may also
use a glass cleaner to clean the
glass on the outside of the door, Do
not let water drip into the vent
openings.
Spillage of marinades, fruit juices,
tomato sauces and basting
materials containing acids may
cause discoloration and should be
wiped up immediately. When
surface is cool, clean and rinse.
Do not use oven cleaners, cleaning
powders or harsh abrasives on the
outside of the door.
If any stain on the door vent trim is
persistent, use a soft abrasive
cleaner and a sponge scrubber for
best results.
TO CLEAN INSIDE OF DOOR
Because the area inside the gasket
is cleaned during the self-clean
cycle, you do not need to clean this
by hand.
The area outside the gasket and
the door liner can be cleaned with
a soap-filled pad, hot water and
detergent. Rinse well with a vinegar
and water solution.
33
Loading ...
Loading ...
Loading ...