Loading ...
Loading ...
Loading ...
Fig. 33
u
Position the handle on the other side.
Fig. 33 (1)
w
The screw holes must be exactly above each other.
u
Tighten the screws with the T15 screwdriver.
Fig. 33 (2)
u
Position the covers on the side and push in.
Fig. 33 (3)
w
Ensure that it clicks into place.
4.3.11 Fitting the bottom door
Fig. 34
u
Carefully lift up the plugs with a slotted screwdriver and
remove them.
Fig. 34 (1)
u
Position the door from above onto the lower bearing pins.
Fig. 34 (2)
u
Insert the centre bearing pin through the centre bearing
bracket into the lower door. Make sure that the catch mecha-
nism is pointing to the rear.
Fig. 34 (3)
u
Insert the plugs again on the other side of the door.
Fig. 34 (4)
4.3.12 Fitting the upper door
Fig. 35
u
Place the upper door on the centre bearing pins
Fig. 35 (1)
u
Align the top of the door with opening in the bearing bracket.
Fig. 35 (2)
u
Insert the bolt and tighten with a T15 screwdriver.
Fig. 35 (3)
u
Fit the protective cover to protect the door: Insert the protec-
tive cover and check that it is attached to the door. If not,
insert the bolt fully.
Fig. 35 (4)
NOTICE
Cable crushing
u
The mark on the cable must be centred in the holder. The
tab with the longer opening must point forwards.
Putting into operation
14 * Depending on model and options
Loading ...
Loading ...
Loading ...