Loading ...
Loading ...
Loading ...
u
Undo the screws with a T25 screwdriver and remove the
bearing bracket
Fig. 29 (3)
Fig. 30
u
Remove the cover and fix it on the other side.
Fig. 30 (1)
u
Place the bearing bracket on the other side and screw in
with the aid of a T25 screwdriver. Start with screw 2 at the
bottom in the middle.
Fig. 30 (2)
u
Screw in screws 3 and 4.
Fig. 30 (3, 4)
u
Rotate the soft stop connection 180°. Screw in with a T25
screwdriver on the other side of the bearing bracket.
Fig. 30 (5)
u
Insert the bearing pin completely. Make sure that the catch
mechanism is pointing to the rear.
Fig. 30 (6)
4.3.9 Moving the door bearing parts to the
other side
Top door
Fig. 31
u
Underside of door faces upwards: Turn the door.
u
Pull out the guide bush: Press the tab with a slotted screw-
driver and, at the same time, insert the slotted screwdriver
under the guide bush.
Fig. 31 (1, 2)
u
Slide the guide bush included in the scope of supply to the
other side of the housing.
Fig. 31 (3)
u
Upper side of door faces upwards: Turn the door.
4.3.10 Moving the handles to the other side
Fig. 32
u
Pull off the cover.
Fig. 32 (1)
u
Remove the screws with the T15 screwdriver.
Fig. 32 (2)
u
Remove the handle.
Fig. 32 (3)
u
Carefully lift up the side plugs with a slotted screwdriver and
pull them out.
Fig. 32 (4)
u
Insert the plugs again on the other side.
Fig. 32 (5)
Putting into operation
* Depending on model and options 13
Loading ...
Loading ...
Loading ...