Loading ...
Loading ...
Loading ...
27
GPF475 Trim Kit
3/4" Custom Panels
Step 3
(continued)
Step 4
Install GPF100
Spring Kit
D.Determine the direction of the wood
grain.
•Drill 1/8" dia. pilot holes, 5/8" deep
through the hole in the support accord-
ing to the direction of the wood grain.
See illustration.
•Install 2 flathead screws through the
support and into the panel.
Caution:
Do not drill pilot holes too deeply to avoid damaging
the appearance side of the panel.
C. Remove the custom panel from the
support.
•Remove tape from adhesive strips on the
metal support – on the side that touches
the custom panel.
•Carefully, position the metal support
onto the custom panel with center line
showing through the triangle. Press the
metal support against the panel.
F. Secure the panel to the door by installing
3 round head screws into the bottom of
the metal support and into the dishwasher
door. Install center screw first, then left
and right screws.
•Press the custom panel against the
dishwasher door.
E. Remove tape from adhesive strips on the
back side of the metal support.
•Carefully, mount the panel onto the
dishwasher by tipping the protruding
metal at the top under and up against the
escutcheon.
This kit must be installed to achieve proper
door balance which is affected by the addition
of a heavy custom door panel.
•Follow the instructions provided with the
GPF100 kit.
Remove
Tape Covering
Adhesive Strips
Screw Holes for Vertical
(Typical) Wood Grain
Screw Holes for Horizontal
Wood Grain Direction
Custom Panel
Install 3 Round
Head Screws
Loading ...
Loading ...
Loading ...