Loading ...
Loading ...
Loading ...
21
GPF400S Trim Kit
Stainless Steel Door and Access Panels
•Remove protective plastic film.
•Tip door panel and slide up and under
bottom and sides of escutcheon.
•Snap door panel over the door and slide
upwards, under the escutcheon.
•Remove protective plastic film.
•Locate and install 2 original screws and
retainers into the top holes of the stainless
access panel.
•Place the stainless access cover on the access
panel assembly.
•Drive 3 screws through the bottom of
stainless cover.
•Center punch and drill one hole into each
side of the stainless cover.
•Install screws supplied.
•Place the toekick against the bottom of the
dishwasher.
•Place the access panel assembly against the
dishwasher and tighten the attached screws.
•Re-install two original bottom screws loosely.
Adjust the toekick up or down and tighten
screws.
Step 2:
Install Stainless
Door Panel Cover
Step 3:
Install GPF100
Spring Kit
Step 4:
Install Stainless
Access Panel
Onto Access
Panel Assembly
•Drive 3 screws into the bottom of the panel
using a phillips head screwdriver.
•Center punch and drill holes through the
holes in the stainless panel and into the
dishwasher door, 2 on each side.
•Install screws supplied.
This kit must be installed to achieve proper
door balance which is affected by the addition
of this stainless door panel.
•Follow the instructions provided with the
GPF100 kit.
Step 5:
Install Access
Panel Assembly
New
Door Panel
Cover
Cover
Retainers
Tighten 2 Screws
Loading ...
Loading ...
Loading ...