Loading ...
Loading ...
Loading ...
11
Installation
CleanSensor Dishwasher
Do not remove wood base until you are
ready to install the dishwasher. The dish-
washer will tip over when the door is
opened.
Step 1
Check
Door Balance
•Remove the 4 hex-head screws holding the
dishwasher to the wood base inside the “U”
frame. Discard screws and base.
•Locate and remove the yellow tape holding
2 Phillips to the top or side of the dish-
washer. These screws are for securing the
dishwasher to the countertop. Set aside for
later installation.
Step 2
Remove
Wood Base
• Unlatch door and remove all foam and
cardboard packaging.
• Check balance by opening and closing door.
If necessary, close latch and adjust one or
both springs before the wood base is re-
moved.
Caution:
Do not attempt to remove the wood base by prying off
or “kicking”. This will cause damage to the dishwasher base.
Move spring hook back to
increase tension.
Note:
Spring hook must be turned to the outside.
Move the dishwasher close to the installation
location and lay on its back.
• Loosen the 4 leveling legs with an adjust-
able wrench and unscrew approximately
3/4".
Step 3
Loosen
leveling legs
CAUTION
Remove and discard
3/8" Hex Head Screws
Approx
. 3/4"
Loading ...
Loading ...
Loading ...