Loading ...
Loading ...
Loading ...
12
Installation
CleanSensor Dishwasher
•Remove the two screws below the access
panel and set aside.
•Loosen the two screws located between the
door and access panel. Do not attempt to
remove these screws. They are secured to
the access panel with washers.
Step 4
Remove
Access Panel
And Toekick
•Remove the junction box cover and install
strain relief and power cord.
The power cord and connections must
comply with the national Electrical Code,
Section 422 and/or local codes and ordi-
nances.
•The cord must be no longer than 6 ft. from
the junction box to the receptacle.
•Connect incoming wires, white to white,
black to black and ground to green wire.
Use UL listed wire nuts of appropriate size.
•Replace the junction box cover. Check to be
sure wires are not pinched under the cover.
Step 5
Install
Power Cord
(If Used)
Skip this step
If dishwasher
will be wired
direct.
•The water valve requires 3/8" NPT fitting
with external threads. The opposite end
should fit water supply line.
•Install the 90° elbow fitting to the water
valve using thread seal tape.
•Position the end of the elbow to face the
rear of the dishwasher.
Caution:
Do not bend the dishwasher frame when installing the
90° elbow fitting to the water valve. This could cause the door
spring to come in contact with the fill hose.
Step 6
Install 90°
Elbow
White
Neutral
Ground
Black
Live
Note: Check That Harness Leads Are
Threaded Thru Small Hole in Bracket
Thread
Seal
Tape
90°
Elbow
Back Out
2 Screws
Access Panel
Toekick
Remove
2
Screws
Loading ...
Loading ...
Loading ...