Loading ...
Loading ...
Loading ...
BEFORE CALLING FOR SERVICE (continued)
PROBLEM
• OVEN WILL NOT SELF-
CLEAN OR POOR SELF-
CLEANING RESULTS
• OVEN DOOR WILL
NOT UNLOCK
• OVEN LIGHT DOES
NOT WORK
• OVEN EMITS ODOR
POSSIBLE CAUSE
Controls set Incorrectly
Clean cycle Interrupted too
soon
Oven too dirty
Clean cycle not complete
Door accidentally locked
while baking or broiling
Light switch In OFF position
Light bulb burned out
Oven Insulation may emit
odor during first few usages
Failure to wipe out excessive
sou during self-cleaning
DON'T CALL FOR SERVICE
UNTIL YOU CHECK
See self-clean Instructions.
Heavily soiled ovens require a 3 1/2 hour
clean cycle.
Heavy spillovers should be removed be-
fore setting clean cycle. Repeat clean
cycle.
Oven must cool below lock temperature.
Turn oven control to OFF. Walt until oven
cools and door will unlock. Do not force
the door lock.
Check switch setting; see operating In-
structions.
Check or replace light bulb; see remov-
able parts section of this manual.
Put oven through a self-clean cycle to
speed up process of odor "wearing off."
Wipe excessive soil before begin nlng self-
clean cycle.
THERMOSTAT ADJUSTMENTS
The temperature In your new oven has been set cor- 3.
rectly at the factory, so be sure to follow the recipe
temperatures and times the first few times you bake in 4.
your new oven.
We do not recommend the use of Inexpensive Ihermom*
etera, such as those found In the grocery store, to
readjust the temperatura setting of your new oven.
These thermometers can vary by 20° - 40°F. Your oven
has been preset to maximize cooking efficiency.
If you think the oven should be hotter or cooler, you can
adjust It yourself. To decide how much to change the
temperature, set the oven temperature 25°F higher or
lower than the temperature In your recipe, then bake.
The results of this "test" should give you an Idea of how
much the temperature should be changed.
To adjust knob:
1. Turn OVEN TEMP KNOBto OFF and removethe knob
by pulling straight off.
2, Look at the back of the knob. The arrow pointing to
the center of the bottom screw Indicates the original
factory setting.
5o
Use a screwdriver to loosen the two screws about 2
turns each.
Hold the knob handle (A on Illustration) while turning
the disk (B on Illustration) In the desired direction to
Increase or decreasethe temperature. (See Illustration
below for"Self-Clean Thermostat.") Asyou turn, you
should be able to hear clicks and feel notches or
teeth. Each click or notch is 15°F. You can turn up
to 2 clicks or notches In either direction.
When you reach the desired adjustment, retlghten
both screws.
"A .... B"
KNOB DISK
TOMAKEOVEN
COOLER
TURNDISK
TOMAKEOVEN
HOTTER
TURN DISK
20 NESER122-1
Loading ...