Loading ...
Loading ...
Loading ...
REMOVABLE KNOBS
MOLDED
RIB
SPRING
CLiP
All control knobs may be removed for easy cleaning by
pulling the knob straight off the stem. Be sure that the
knob Is In the OFF position before removal.
Hint: Slip a thin cloth (such as a handkerchief) or a plsce
of string under and around the knob edge and pull up.
Caution: Read these In_ructlons carefully before re-
plsclng the knobs. Rsplaclng the knobs Improperly will
damage the knobs and the spring clips on the stems. If
this happens, the knobs will fit loosely.
To replace the knob:
1. The knob stem has a groove In each side. The
groove on one side has a spring clip. The other
groove Is clear (see Illustration).
2. Check the Insldeof the knob and find the molded rib.
3. Replacethe knob by tlttlng the molded rib Inside the
knob Into the clear groove on the stem.
Note: Be sure to replace knobs on the correct
sternso.
REPLACING THE OVEN LIGHT
GLASS
RETAINER
BULB
GLASS
COYER
Be sure that the light switch is in the off position.
Do not touch hot oven bulb. Do not touch oven
bulb with wet hands, Do not wipe oven light area
with wet cloth.
Never touch the electrically live collar on the
bulb when replacing it.
Electrical power must be shut off if you have to
replace a broken bulb.
1. Unscrew glass cover and remove.
2. Replace the bulb with a 40 watt appliance bulb.
3. Replace the cover.
Note: We recommend you use a 40 watt appliance bulb
that Is no longer than 3 1/2".
LIFT-UP COOKTOP
SUPPORT RODS
The cooktop can be
relsed sothearea under-
neath can be cleaned.
Raise the front of the
cooktop until the sup-
port rods snap Into posi-
tion to hold the cooktop.
TO lower cooktop, push
In on the front of the sup.
portswhlle lowering top.
Porcelain enamel
can chip if dropped. Handle poreelain enameled
cooktops carefully,
REMOVABLE COOKTOP UNITS
Do not put the element into water. It cleans Itself when
heated during normal use.
Be sure all cooktop unit control knobs are tumealoff and
elements are cool before you remove or replace s
cooktop unit.
To remove:
,
Grasp element, tilt It upward slightly to clear the
bowl, then pull away from the receptacle. The
element will not sit level when replaced If ItIs forced
too far upward when removed. Lift out the bowl.
IMPORTANT: Never operate a cooktop elemnt
without the bowl in place. This can cause
scorching of tire cnoktcp, burning of wiring insu-
lation and loss of energy.
DO not lift plug.in unit more than 1 ". If you do, it
may not lie flat on the drip bowl when you plug It
hack in.
Repeated lifting of the plug-in unit more than t"
above the drip bowl can permanently damage
the receptacle.
To replace:
1. Repiacethebowl. Besurethereceptacleisshowlng
In the bowl opening.
2. Slide the plug of the element firmly Into the recep-
tacle and lower the element Into place.
18
NEMNT108
Loading ...
Loading ...
Loading ...