Loading ...
Loading ...
Loading ...
EN
17
Device description
www.bora.com
Pay attention to the cookware bottom. The base of
the cookware should not show any sign of curvature.
Due to incorrect temperature monitoring of the hob
caused by the air gap between the cookware and the
temperature sensor underneath the hob, overheating
may occur. The bottom of the cookware must not have
any sharp grooves or sharp edges to avoid scratching
the cooktop.
Place the cookware (without a mat or similar) directly
onto the glass ceramic.
Noises
The following noises may occur in the cookware when
using induction cooking zones, depending on the material
and the finish of the base:
Humming may occur when using a high power level. It
decreases or disappears if the power level is decreased.
Crackling or whistling may occur due to the bases of
cookware made of different materials (e.g. sandwich
base).
Clicking sounds may occur during electronic switching
procedures especially at low power levels.
Whirring may occur when the cooling fan is switched
on. In order to increase the service life of the
electronic system, the cooktop is equipped with a
cooling fan. The cooling fan switches on automatically
if the cooktop is used intensively. You will hear a
whirring sound. The cooling fan may continue running
after the device has been switched off.
5.4 Functional principle of the
cooktop extractor
5.4.1 Freely adjustable power control
The power levels are controlled using the central setting
field on the operating panel.
5.4.2 Automatic cooktop extractor function
The automatic cooktop extractor function adjusts the
extraction performance (power level) to the highest
cooking zone cooking level used.
Function Power levels
Extractor level 4 4 4 4 5 6 7 8 9 P
Cooking level 1 2 3 4 5 6 7 8 9 P
Tab. 5.6 Extraction performance and cooking level
If the power level of the cooking zones is changed,
the automatic cooktop extractor function adjusts the
cooktop extractor performance after a 30 second
delay.
Once the cooking session is complete, the automatic
after-run is activated.
5.3.6 Pause function
The cooking session can be temporarily interrupted.
I I
appears in the display.
The cooking session and set timer are interrupted
while the pause function is active.
The pause function is limited to a maximum duration of
10 minutes.
5.3.7 Timer functions
You can use 2 timer functions:
Short-time timer (egg timer), no automatic switching
off of a cooking zone.
Automatic cut-off for automatically switching off a
cooking zone.
5.3.8 Pan size recognition
The cooking zone does not work
if
v
is shown in the display;
if it is switched on without cookware or with
unsuitable cookware;
if the base diameter of the cookware is too small;
if the cookware is removed from a switched on
cooking zone.
After 10 minutes have passed without a pan being
detected, the cooking zone will switch off automatically.
5.3.9 Suitable cookware
INFO The heating and heat through time for the base
of the cookware as well as the cooking results
are significantly influenced by the structure and
material of the cookware.
Cookware with this symbol is suitable for
induction cooktops.
The cookware used for the induction cooktop
must be made of metal, feature magnetic
properties and possess a sufficient bottom
surface.
Suitable cookware is made of:
stainless steel with a magnetisable base
enamelled steel
cast iron
Cooking zone Minimum diameter
Front 120 mm
Back 120 mm
Tab. 5.5 Minimum cookware diameter
Perform a magnet test, if necessary. If a magnet sticks
to the base of the utensils, they are normally induction
compatible.
Loading ...
Loading ...
Loading ...